There are three components of the A-Pillar Device Mount.
- The Clip – attaches to the drivers’ side a-pillar of your Fiesta
- The Arm – attaches to the Clip and to the Mounting Plate.
- The AccessPort Mounting Plate – attaches to the mounting panel that came with your Cobb AccessPort. Note: Two extra universal mounting plates included.
Note: On very hot summer days where inside car temps may reach 150°F while parked, it is advised that when exiting the vehicle you remove the AccessPort device from the cradle to avoid the weight and extreme heat from causing the Arm to deform.
Install the Clip to the A-pillar
Plastic tab on a-pillar is above the Clip.
- Slide the back of Clip around back of the a-pillar trim.
- Pull back the rubber molding from the front of the a-pillar trim.
- Push the clip over the plastic molding as shown.
- Firmly push the Clip until both top and bottom of clip snaps around the molding.
NOTE: The Clip is a tight fit onto the A-Pillar. If you are having trouble getting the clip to snap into place on the front, try adjusting the height of the front or back of the clip on the a-pillar and keep trying. Eventually you’ll get it to snap into place.
Install Mounting Plate onto Arm
- Insert the three prongs of the arm into the back of the mounting plate.
- Mount can be installed inverted to change the height.
- Push firmly until the prongs are seated completely.
Install the Arm onto the A-Pillar Clip
- Slide the Arm down into the top of the Clip.
- Press down firmly to ensure the Arm seats fully into the Clip
- Fitment should be firm with little wiggle room.